How to Choose Between 28H, 32H and 36H Configurations for an MTB Hub Set
The spoke-hole count is one of the first numbers a product manager writes into an MTB hub-set specification, and it is also one of the easiest to over-simplify. A 28…
Read moreThe spoke-hole count is one of the first numbers a product manager writes into an MTB hub-set specification, and it is also one of the easiest to over-simplify. A 28…
Read moreChoosing a GNSS/GPS antenna is really two linked decisions: the antenna architecture that suits your receiver chain, and the frequency bands that match the positioni…
Read moreWhy an Antenna Behaves Differently Inside an Enclosure An antenna that meets its return loss and efficiency targets on a bare test board can lose bandwidth, shift re…
Read moreTrail riders notice hub pickup most when they least want to: a half-pedal out of a slow corner, a quick corrective stroke on a climb, or a short burst to clear a roo…
Read moreSpecifying a custom RF antenna cable assembly is not simply a matter of choosing a connector and a length of coax. For wireless equipment makers, the assembly sits b…
Read moreFor a disc road wheel program, the freehub body is often the last specification locked in and the first one to cause a build delay. A hub set can have the right dril…
Read moreFor buyers sourcing a custom antenna, the first question is rarely about a single specification. It is about how far a manufacturer can carry a project—whether the s…
Read moreRoad disc hub specification goes wrong in a predictable way: the hub looks right in a drawing, the finish and weight are acceptable, and then the first frame or driv…
Read moreWhat a Combination Antenna Actually Does in a Multi-Band Device A multi-band wireless device rarely has room for several separate antennas. Cellular, WiFi, and GNSS…
Read moreThe quickest way to avoid a costly sampling cycle is to treat 12×100mm front and 12×142mm rear thru-axle spacing as a fit commitment rather than a headline number. F…
Read more